Delete Reciver/boot.py

Reciver/boot.py

@@ -1,37 +0,0 @@
-import storage
-import board
-import digitalio
-
-# --- Configuration ---
-# Set up the two pins we want to check
-pin16 = digitalio.DigitalInOut(board.IO16)
-pin16.direction = digitalio.Direction.INPUT
-pin16.pull = digitalio.Pull.UP
-
-pin17 = digitalio.DigitalInOut(board.IO17)
-pin17.direction = digitalio.Direction.INPUT
-pin17.pull = digitalio.Pull.UP
-
-# --- Logic ---
-# By default, the pull-up resistors hold the pins HIGH (True).
-# If we short a pin to GND, its value will become LOW (False).
-
-# We check if BOTH pins are HIGH.
-# If they are, it's a "normal boot," so we hide the drive.
-if pin16.value and pin17.value:
-    print("Normal boot: Disabling CIRCUITPY drive.")
-    storage.disable_usb_drive()
-else:
-    # One of the pins was LOW (grounded), so we
-    # enable the drive for maintenance.
-    print("Storage boot: CIRCUITPY drive is ENABLED.")
-    # We don't need to call storage.enable_usb_drive()
-    # because it's enabled by default.
-
-# Clean up the pins so they can be used in code.py if needed
-pin16.deinit()
-pin17.deinit()
-
-# The boot.py file finishes, and CircuitPython will
-# either mount the drive or not, based on what we did.
-# After this, code.py will run.